Mercedes S-Class W-140

In 1991-1999 editions

Repair and enterprise of the car

Mercedes S-Class
+ Mercedes Benz cars of the class S (W-140)
+ operation manual
+ Routine maintenance
+ motor
+ cooling systems, heating
+ systems of power supply and edition
+ electric equipment of the motor
+ Gear shifting boxes
- awtomatitscheckaja transmission
   Specifications
   Search of defects - the general information
   - Automatic transmission 722.5
      Removal, check of a state and device of the reformer of Drehens (hydro-transformer)
      Removal and device of the centrifugal regulator
      Removal and device of the touch switch of blocking of a starter (solution of start)
      Vacuum knot - a device detail
      Removal, service and the device of the repeated pump (AT to No. 3652931)
      Removal and device of a forward cover of the repeated pump
      Removal and device of the LB3 piston
      Removal and device of a back cover of transmission
      Discussion and installation of installation of AT valves
      Discussion and installation of transmission
      The device and check of freedom of action in Mehrscheibenbremse B3
      Measurement of freedom of action in B1 brake
      Connection of the raising transfer
      Removal, the device and check of components of a brake of BS of the raising transfer and the KS connection
      Discussion and installation of mufty of the free movement
      Discussion and installation of planetary mechanisms
      Discussion and installation of the K1 connection
      K2 connection
      Gear shifting Selektors lever
   + Automatic transmission 722.6
+ connection
+ brake system
+ Aufhängung and management
+ body
+ electric onboard equipment

Removal and device of the centrifugal regulator

Removal

Details of the device of the centrifugal regulator

EXECUTION ORDER

1. Lift transmission.
2. Accept a cross strip of the motor (19). Accept the carrier (10) at a pipe of the sequence and the clip (11), Muttern (7) prevented.
3. Accept a board (5).
4. Exclude forward kardannyj a wave (71) from transmission gears.
5. Exclude sewer (60) from a back support.
6. Prevent a wave of a speedometer (9) or an inductive sensor (85a).
7. Press a cover (46) and accept a blocking ring (43) and uplotnitelnoje a ring (48).

8. Turn a flange in such a way that the centrifugal regulator (50) was installed in situation which is shown on illustrations.
9. Establish nippers, squeeze a blocking ring (43) and accept the regulator (50).

Device

EXECUTION ORDER

1. Turn transmission gears to the right and install the regulator (50) by means of nippers (072).
2. Establish uschko (arrows) in a flute in a regulator body. Are convinced that the blocking ring is blocked in a flute. If the regulator is correctly defined, the blocking ring can easily rotate in a flute.
3. Check a condition of uplotnitelnogo of a ring (48) and if it is necessary, replace it.