Mercedes S-Class W-140

In 1991-1999 editions

Repair and enterprise of the car


Mercedes S-Class
+ Mercedes Benz cars of the class S (W-140)
+ operation manual
+ Routine maintenance
+ motor
+ cooling systems, heating
+ systems of power supply and edition
+ electric equipment of the motor
+ Gear shifting boxes
- awtomatitscheckaja transmission
   Specifications
   Search of defects - the general information
   - Automatic transmission 722.5
      Removal, check of a state and device of the reformer of Drehens (hydro-transformer)
      Removal and device of the centrifugal regulator
      Removal and device of the touch switch of blocking of a starter (solution of start)
      Vacuum knot - a device detail
      Removal, service and the device of the repeated pump (AT to No. 3652931)
      Removal and device of a forward cover of the repeated pump
      Removal and device of the LB3 piston
      Removal and device of a back cover of transmission
      Discussion and installation of installation of AT valves
      Discussion and installation of transmission
      The device and check of freedom of action in Mehrscheibenbremse B3
      Measurement of freedom of action in B1 brake
      Connection of the raising transfer
      Removal, the device and check of components of a brake of BS of the raising transfer and the KS connection
      Discussion and installation of mufty of the free movement
      Discussion and installation of planetary mechanisms
      Discussion and installation of the K1 connection
      K2 connection
      Gear shifting Selektors lever
   + Automatic transmission 722.6
+ connection
+ brake system
+ Aufhängung and management
+ body
+ electric onboard equipment


K2 connection

Discussion

K2 connection design

1 — support of external Disks
2 — the piston
3 — a feather
4 — the Rise-strong plug
5, 11 — blocking rings

6 — Internal Disk
8, 10 — External Disks
12, 13 — Uplotnitelnyje of a ring
020 — tiskalshchik
A — freedom of action in the K2 connection


 EXECUTION ORDER

1. Accept a blocking ring (11) from external support (1) of external Disks of connection.
2. Accept Disks (6), (8) and (10). Check Disks for lack of sale and damages.
3. Establish a tiskalshchik (020) on rise - the strong plug (4) and accept a blocking ring (5).
4. Accept rise - the strong plug (4) and a feather (3).
5. Pull out the piston (2) to support (1).
6. Be lowered by ring uplotnitelnyje (12 and (13) from the piston (2).

Installation

 EXECUTION ORDER

1. Establish ring uplotnitelnyje (12 and (13) on the piston (2). Pursue that uplotnitelnyje edgings of perekrutscheny did not appear and were defined in the direction of an arrow.
2. Install the plug (021) on support (1), grease the plug (021) and uplotnitelnyje of a ring (12) and (13) transmissionnym from oil, install the piston (2) in support of (1) carefully, sapressujte the piston (2) without Verkantung, it turning a little.
3. Establish rise - the strong plug (4) and a feather (3).
4. Establish a tiskalshchik (020) on rise - the strong plug (4) and establish a blocking ring (5).
5. Establish Disks (6), (8 and (10) in support of (1).
6. Establish a blocking ring (11).

Check of freedom of action

Check freedom of action of "A". The nominal size of freedom of action "And" in the K2 connection lies in borders of the volume of 0.7-1.3 mm you regulate freedom of action with the road of the choice of a blocking ring (11). Blocking rings of thickness of 2.0, 2.5 and 3.0 mm are issued.