Mercedes S-Class
+ Mercedes Benz cars of the class S (W-140)
+ operation manual
+ Routine maintenance
+ motor
+ cooling systems, heating
+ systems of power supply and edition
+ electric equipment of the motor
+ Gear shifting boxes
- awtomatitscheckaja transmission
Specifications
Search of defects - the general information
- Automatic transmission 722.5
Removal, check of a state and device of the reformer of Drehens (hydro-transformer)
Removal and device of the centrifugal regulator
Removal and device of the touch switch of blocking of a starter (solution of start)
Vacuum knot - a device detail
Removal, service and the device of the repeated pump (AT to No. 3652931)
Removal and device of a forward cover of the repeated pump
Removal and device of the LB3 piston
Removal and device of a back cover of transmission
Discussion and installation of installation of AT valves
Discussion and installation of transmission
The device and check of freedom of action in Mehrscheibenbremse B3
Measurement of freedom of action in B1 brake
Connection of the raising transfer
Removal, the device and check of components of a brake of BS of the raising transfer and the KS connection
Discussion and installation of mufty of the free movement
Discussion and installation of planetary mechanisms
Discussion and installation of the K1 connection
K2 connection
Gear shifting Selektors lever
+ Automatic transmission 722.6
+ connection
+ brake system
+ Aufhängung and management
+ body
+ electric onboard equipment
|
Removal, check of a state and device of the reformer of Drehens (hydro-transformer)
Removal
|
|
| 1. Install transmission gears of the reformer of Drehens upward. |
2. Turn a plastic finger of the reformer of Drehens on 1/4 changes against the direction clockwise.
3. Priwernite of a hvataniye (065) on the reformer of Drehens |
|
| 4. Pull out the reformer of Drehens. |
|
Check
The body of the reformer of Drehens has following nominal volumes of a chest:
| Diameter, millimeter |
270
|
| Height, millimeter |
| New installation |
120.7
|
| Extremely admissible value |
121.5
|
|
|
|
1. Establish the reformer of Drehens in duty with the repeated pump of a key flange upward on a measuring disk (05).
2. Measure height of a chest of "A" of a body of the reformer of Drehens. If the result of measurement passes admissible Höchstbedeutung, replace the reformer. |
|
|
Device
|
|
| 1. Grease a flange about (32) means of Molykote. |
|
2. Establish a plastic finger and turn it on 1/4 changes clockwise.
3. Prevent hvataniye (065) from the reformer of Drehens. |
|
| 4. By means of a measuring latch you measure the size wystupanija "A" of the reformer of Drehens over the connected surface of kartera of transmission. Face value forms 9.6 mm. |
|
|
|
|