Mercedes S-Class W-140

In 1991-1999 editions

Repair and enterprise of the car


Mercedes S-Class
+ Mercedes Benz cars of the class S (W-140)
+ operation manual
+ Routine maintenance
+ motor
+ cooling systems, heating
+ systems of power supply and edition
+ electric equipment of the motor
+ Gear shifting boxes
- awtomatitscheckaja transmission
   Specifications
   Search of defects - the general information
   - Automatic transmission 722.5
      Removal, check of a state and device of the reformer of Drehens (hydro-transformer)
      Removal and device of the centrifugal regulator
      Removal and device of the touch switch of blocking of a starter (solution of start)
      Vacuum knot - a device detail
      Removal, service and the device of the repeated pump (AT to No. 3652931)
      Removal and device of a forward cover of the repeated pump
      Removal and device of the LB3 piston
      Removal and device of a back cover of transmission
      Discussion and installation of installation of AT valves
      Discussion and installation of transmission
      The device and check of freedom of action in Mehrscheibenbremse B3
      Measurement of freedom of action in B1 brake
      Connection of the raising transfer
      Removal, the device and check of components of a brake of BS of the raising transfer and the KS connection
      Discussion and installation of mufty of the free movement
      Discussion and installation of planetary mechanisms
      Discussion and installation of the K1 connection
      K2 connection
      Gear shifting Selektors lever
   + Automatic transmission 722.6
+ connection
+ brake system
+ Aufhängung and management
+ body
+ electric onboard equipment


Measurement of freedom of action in B1 brake

Preparation

 EXECUTION ORDER

1. Install radial network (39) in the piston of a brake B1 (37).
2. Install a finger during the transferrings and uplotnitelnym from a ring in B1 brake piston. uplotnitelnaja the edging has to be located outside.
3. Strengthen a tiskalshchik (026) and priwernite on transmission gears, establish measuring institution (031).
4. Install the piston of a brake B1 (37) with a press spring.
5. Priwernite on a spindle institution (026). Are convinced that the finger of the piston of a brake of B1 (37) which is defined on a brake tape and radial network (39) are not injured.
6. Establish a blocking ring (41), weaken and accept institution (026).

Measurement and regulation of freedom of action

 EXECUTION ORDER

1. Priwernite measuring establishment (031) by hand to resistance.
2. You screw up a key on the bolt interested measuring establishment (031) for a bolt, number of changes prudently until the moment not to be to clear up in 1 N.Resba of measuring establishment a step of 1 millimeter so change equals to freedom of action in 1 mm.
3. Weaken establishment (026) and accept the brake piston if it is necessary.
4. Regulate the freedom of action established or, transferrings (136) on a finger (38) it is accepted. Thickness of transferrings: 0.5, 1.0 and 1.5 mm.
5. Establish a cover (40) to the piston of a brake and the second press spring (35) into place in measuring establishment, establish a blocking ring and prevent institution (026).