Mercedes S-Class W-140

In 1991-1999 editions

Repair and enterprise of the car

Discussion and installation of the K1 connection

Discussion

Discussion and installation of the K1 connection


83a — the External support of the K1 connection 83b — Uplotnitelnoje a ring 86 — the piston 86a — Uplotnitelnoje a piston ring 86b — a feather of glasses 87 — the Rise-strong disk	87a — Uplotnitelnoje a ring rise - a strong disk 88, 90 — blocking rings 89 — the Disks block 91 — a blocking ring of mufty of the free movement 92 — a hall of mufta of the free movement A — the Fat channel for the K1 connection

EXECUTION ORDER

1. Accept a blocking ring (90) from an external support. 2. Accept the Disks (89) block from an external support.
3. Establish a tiskalshchik (072) on rise - a strong disk (87) and squeeze them until the blocking ring (88) is not released.
4. Accept a feather of glasses (86b) and the piston (86) in which opening (A) compressed air serves.

Installation

Check of freedom of action between a blocking ring (90) and external Disk (89c)


83a — the External support of the K1 connection 86 — the piston 86b — a feather of glasses 89a — External Disk (thickness of 1.8 mm) 89b — External Disk (thickness of 3.5 mm / new thickness of 2.8 mm)	89c — External Disk (thickness of 4.0 mm) 89d — Reibscheiben 90 — a blocking ring L — freedom of action

Installation will be as it should be, carried out down discussions. Check freedom of action between a blocking ring (90) and external Disk (89c). The size of freedom of action in the K1 connection of a nizheperechislen in the table. As a last resort you regulate freedom of action by means of selection of a blocking ring (90) necessary thickness. Rings of thickness of 2.6, 2.9, 3.2, 3.5, 3.8 and 4.1 mm are issued.

The size of freedom of action in the K1 connection

Disk	Size of freedom of action, millimeter
3	2.70-3.10
4	3.00-3.40
5	3.30-3.70