Mercedes S-Class W-140

1. Accept a blocking ring (134a).
2. Accept the Disks block of a brake B2 (134) and a feather of glasses (134b) from an external support of a brake B2.
3. Establish a tiskalshchik (074) on a feather of glasses (29) and compress them until the fold is not released for a blocking ring.
4. Accept a blocking ring (31).
5. Accept rise - a strong disk (30) and a feather of glasses (29).

1. Exclude the piston and the piston of a brake B2 (27) judging a ring (28) from the W3 piston (14a) which serves compressed air in opening (D).
2. Wypressujte the judging ring (28) from the W2 (27) piston.

1. Establish sending (32) and W3 pistons (14a) to the correct situation. For this purpose, you establish sending (32) to a body of transmission (2) and you tighten. An external support of a brake B2 (14a) before blow in sending to Sapressujte (32). Wytotschka on an external support of a brake B2 (14a) have to be directed to schlizach or a part (arrows) down.
2. Install the piston of a brake B2 (27) in B3 brake piston (14a). sakruglennyje the ends of uplotnitelnych of rings (14c), (28a) and (28b) have to be directed outside of Sakruglennyj the end of uplotnitelnogo of a ring (14d) has to be directed in inside.
3. Establish the judging ring (28) to the piston. The gate (137) in the judging ring of the piston has to be above.
4. Establish a feather of glasses (29) and rise - a strong disk (30).
5. Establish a tiskalshchik (074) on a feather of glasses (29) and compress them until the fold is not released for a blocking ring.
6. Establish a blocking ring (31).
7. Establish a feather of glasses (134b) and the Disks (134) block on an external support of a brake B2.

1. Establish Disks of a brake B3 V3vmeste as it should be which is presented on the accompanying illustration and establish them in turn.
2. Establish the press (078) on external Disk (70c).
3. Squeeze out the Disks block by means of the press before blow until otmetotschnoje a ring (which will be noticeable little shooters) together.
4. Measure freedom of action of "L" in 3 points between a blocking ring (144a) and external Disk (134a). The size of freedom of action in Mehrscheibenbremse (82) nizheperechislena in the table.
5. As a last resort regulate freedom of action by means of the choice of a blocking ring (144a) to the necessary thickness. Rings of thickness of 2.9, 3.2, 3.5, 3.8 and 4.1 mm are issued.
6. Establish a blocking ring (134a).