Check of a condition of a bent shaft
The name on a forward part of a bent shaft
|
|
|
1 — an emblem of the enterprise
2 — a model name
3 — date of check |
4 — control category of automatic measuring system
5 — Thoroughly schejka of a bent shaft
6 — width of a certain appendix |
rasmernyje of the characteristic of a bent shaft are presented in specifications. The name on a forward part of a bent shaft is submitted on sopr. Illustrations.
Measurement of volumes of schejek of a bent shaft and device of new appendices
|
|
|
1. Accept a bent shaft and establish covers of thorough camps of a bent shaft and tighten them to 30 Nanometers.
|
| 2. Measure diameter of opening under the thorough camp and diameter thoroughly of schejki. |
|
3. Selection of appendices is made the next way:
Diameter of opening under the thorough camp (62.51 mm) - diameters thoroughly schejki (57.95 mm) = 4.55 mm - Radial freedom of action (0.04 mm) = 4.51 mm / 2 = the appendix thickness (2.25 mm).
On the basis of results of calculation the top blue appendix and the lower appendix arrives "blue" (outside watch specifications).
4. Face values of rooms of a running cycle and on one axis of ljuftow of thorough camps of a bent shaft form: 0.030-0.045 mm and respectively 0.100-0.250 mm.
5. The room of a running cycle in schatunnych of the camp forms 0.020-0.050 mm.
6. Final volumes and the name of opening under thoroughly schejki of a bent shaft are specified in specifications. |
|
|