Mercedes S-Class W-140

1. Accept a tax crevice.
2. Accept network (71c) from the lower part of a tax wave.
3. Exclude the lower tax wave (80a).

1. Check a cross beating of the lower tax wave (80a).
2. Accept the lower carrier (82).
3. Install height regulator in average situation.
4. Accept an incentive of regulation of an arrangement of a tax crevice (the top part / the lower part) (î20m2).
5. Be lowered by teleskopitscheski a regulation incentive (inside / later outside) (î20m1).
6. Accept a support of a tax crevice (83).
7. Accept the carrier (85).
8. Prevent a bolt (86) strengthenings of a cover and pull out an internal pipe from an external pipe down.
9. Order an internal pipe.

1. Collect an internal pipe.
2. Grease an internal pipe (81b) and establish them below in an external pipe.
3. Turn in directing a bolt (86), a fold on an internal pipe (81b) with a bolt it is combined.
4. Establish teleskopitscheski a regulation incentive (inside / later outside) (î20m1).
5. The installation as it should be which is carried out down removals will be farther. The maximum admissible beating of the lower tax wave forms 2.0 mm.