| 1. Establish doors on the aligning bolts, pneumatic lines and the electric leading device is at the same time installed by a forward rack. |
|
| 2. Turn bolts and tighten 37 Nanometers from its moment.
|
|
| 3. Connect or weaken a protective sleeve and a bolt of a door at a forward rack. |
|
| 4. Connect all line of a door of the driver in the line plug in a floor and strengthen from her fixing tape. Install the panel on a floor. Accept a support of a door and check freedom of action between a door and a body, regulate it if it is necessary. |
|
| 5. Turn bolts of strengthening of a support of a door, but do not tighten them. |
|
| 6. Regulate the provision of a door of the driver in such a way that the sapodlizo panel with a forward wing was or it on 1 mm below. Check regulation of a back door. |
|
| 7. Regulate a door support in such a way that the door was closed completely, and regulate a door, translating a support in such a way that the door with a back door was up to standard or on 1 mm it is higher. |
|
| 8. Tighten bolts of strengthening of a support of a door of the moment of 20 Nanometers.
|
| 9. Check a contour of a door and establish a window frame. Check a door for ease of shift. |
|