| 1. Check Kodes of waves of curves. A code of a wave of curves it is beaten out on schejke of the 3rd camp and on a flange of a wave of curves. |
|
| 2. Establish a small fist of the cylinder 1 or 6 of working prevoskhodstvo upward in such a way that he did not press the hydro-compensator. |
|
| 3. Establish a bolt from (02) slice the plug (04) on the contact surface of the head of the block of cylinders of the tested wave of curves. |
|
| 4. Install the digital device (01) with schtschupom (03) (80 mm) on a bolt (02) to the tested wave of curves at the left. Establish schtschup with a preliminary suit of 3 mm and at an angle 90 ° to the hydro-compensator. |
|
| 5. Turn a bent shaft by means of a key in the direction of Drehens until the digital device does not show raising of the gate on 2 mm. In this situation you check the phase Aufmachens of the tested gate after glass of a bent shaft and you compare to data in the following table. |