Mercedes S-Class
+ Mercedes Benz cars of the class S (W-140)
+ operation manual
+ Routine maintenance
+ motor
+ cooling systems, heating
+ systems of power supply and edition
+ Electric equipment of the motor
- Gear shifting boxes
Specifications
Removal and device of transmission gears
Forward cover of transmission gears - a device detail
Removal and device of a back cover of transmission gears
+ RKPP 717.438
+ RKPP 717.454
+ Awtomatitscheckaja transmission
+ connection
+ brake system
+ Aufhängung and management
+ body
+ electric onboard equipment
|
Removal and device of a back cover of transmission gears
Removal Details of the device of a back cover of transmission gears
|
|
|
5 — a sign of protection of heat
6, 7, 88 — mother
9 — a speedometer wave
10 — the sewer strengthening carrier
11 — a clip
19 — a motor support
50 — transferring
|
56 — Mufta Synchronisators
60 — system of the edition
67 — a flange
71 — Forward kardannyj a wave
82 — the Back cover of transmission gears
85a — the Inductive sensor
89 — a bolt |
|
|
1. Prevent a support of the motor (19).
2. Prevent the carrier (10) strengthenings of system of the edition and a clip (11).
3. Prevent a sign of protection of heat (5).
4. Prevent forward kardannyj a wave (71).
5. Exclude system of the edition (60) from the back kroplenija point.
6. Prevent a wave of a speedometer (9) or an inductive sensor (85a).
7. Prevent mother (88).
8. Accept a flange (87).
9. Exclude a back cover of transmission gears (82). |
|
Discussion Discussion and installation of a back cover of transmission gears
|
|
|
58 — Mufta of switching
59 — a switching fork
61 — the lever
65 — transferring
66 — bolts
67 — a wave |
08 — Uplotnitelnoje a ring
69 — a tension spring
81 — the camp in the form of a needle
82 — the Back cover of transmission gears
86 — Radial network |
|
|
|
1. Prevent bolts (66) and accept a wave (67). |
|
2. Accept the lever (61), a fork (59) and muftu (58). Pull out muftu (58), a fork (59) from the lever (61) and accept a tension spring (69). |
|
|
3. Pull out the camp in the form of a needle (81) from a cover.
4. Wypressujte radial network (86). |
|
Installation and device
|
|
Establish a fork (59) on muftu (58) in such a way that freserowannaja a surface of a fork (59) about (the shooter it was located) |
Installation and the device are made as it should be, down removals and discussions. Establish a fork (59) on muftu (58) in such a way that the surface of a fork (59) was located freserowannaja above.
|
|
The tension spring (69) has to be defined on a lever cuff |
At the device you send the gear shifting lever to a fork of the 5th transfer and transfer of a backing (shooter). Prowernite switching bank you strike just in them in a fold of a body of Synchronisators (56).
|
|