Mercedes S-Class W-140

In 1991-1999 editions

Repair and enterprise of the car

Mercedes S-Class
+ Mercedes Benz cars of the class S (W-140)
+ operation manual
+ Routine maintenance
+ motor
+ Cooling systems, heating
- Systems of power supply and edition
   + system of power supply and an injection of the combustible petrol engine - the general information
   + system of an injection of the combustible diesel engine - the general information
   + tax system injection of fuel and ignition of HFM-SFI (6-cylinder petrol engines)
   + tax systems LH-SFI and ME-SFI motor (8-cylinder petrol engines)
   + tax systems injection of fuel and ignition of ME-SFI and LH-SFI (12-cylinder petrol engines)
   - Tax system fuel injection (diesel engines of the OM603.971 series)
      Removal and the device of the pump for the combustible high pressure (TNWD)
      The fuel injection moment regulator - a device detail
      Removal and device of a turbocompressor
   + tax system fuel injection (diesel engines of the OM606.961 series)
   + system of a turbo charging - the general information
   Systems of immersion of toxicity of the edition - the general information
   System of the edition of the working gases - the general information
   Catalytic reformer (petrol models)
+ electric equipment of the motor
+ gear shifting boxes
+ Awtomatitscheckaja transmission
+ connection
+ brake system
+ Aufhängung and management
+ body
+ electric onboard equipment

Removal and the device of the pump for the combustible high pressure (TNWD)

Removal

EXECUTION ORDER

1. Weaken the central bolt (19) and prevent it, supported in a bent shaft.
2. Bring the motor into situation 15 ° after the WMT piston of the first cylinder.
3. Be lowered by chain natjaschitel by means of a key (156).
4. Exclude aggravating topliwoprowody.
5. Exclude listeners of vacuum of knot of vacuum and the gate of vacuum. Exclude the contact plug 2 incentives (Y22) of management of a pipe of idling. 6. Exclude the electric leading device of a sensor of situation rejki (L7) and from an incentive (Y22). 7. Exclude the aggravating listener of the ALDA hub. 8. Exclude an accelerator pedal draft ton of rejki and feather. 9. Exclude the control gate of vacuum.
10. Prevent bolts (shooter). Be lowered by TNWD back, strengthen the fuel injection moment regulator on the place.
11. Accept the thermostat of fuel and prevent bolts.
12. Check correctness of the device of the piston of the 1st cylinder in situation 15 ° after WMT.
13. Prevent a stopper (11).
14. By means of a key (027) prowernite TNWD wave in such a way that in opening uschko of the switch was obvious and you strike a bolt of the block (023) before blow.

Device

EXECUTION ORDER

1. Accept a bolt of the block (023) after the TNWD device.
2. Install all accepted elements on the motor. 3. Check the beginning of an injection of fuel and if it is necessary, regulate it. 4. Install the gate of vacuum and regulate it.